Battery Flash
Tips for conserving battery
Are you always running out of battery just before taking that perfect shot with your digital camera? Here are some
battery-saving tips when you are out "snapping away".
1) Turn off your digital camera when not in use. If you is in a situation where you must snap pictures quickly, this can not
apply as turning digital cameras on and off a few seconds, and can cause you to miss a chance of taking photographs.
However, if you take a stroll and can afford a couple of seconds before taking a still subject, by all
the media, to preserve the power of your digital camera!
2) Many digital cameras have a regular viewfinder and an LCD display. While the digital LCD viewfinder has its advantages,
it can drain battery power. Turning it off when applicable and use your regular viewfinder for taking photographs.
3) Do not stop after taking the photo and view the image in playback mode of your digital camera. Of course, you sometimes
need look at the photos immediately after shooting in order to ensure that your exposure is correct, the lighting is good,
, Etc., but doing this depletes the battery of your digital camera.
4) If you are using MicroDrive media, be forewarned that these miniature hard drives may take significantly more power
Compact Flash Cards.
Seeing that the new battery
Normally, a new battery comes in a condition of low load and must be fully charged before use. See the user
manual of your portable electronic equipment for charging instructions. A new battery pack must be fully charged and
fully discharged or "cycle" as much as five times to condition them in the fulfillment at full capacity. Your computer may
a status report fully in charge as little as 10 to 15 minutes, when the new battery pack is charging in the first
time. This is a normal phenomenon especially for Nickel Cadmium (Ni-Cd) and nickel-metal hydride (Ni-MH) chemistry. When
this happens, remove the package from the battery and let it cool
down for about fifteen minutes then repeat the charging procedure. "Conditioning" (fully and then fully charge)
is necessary to maintain optimal performance of a battery pack and is recommended at least once a month
particularly for Ni-Cd and Ni-MH. Failure to do so could result in the ability load significantly reduced and may
shorten battery life. Lithium ion batteries do not require conditioning. It is normal for a package Battery
warm during charging and during use. However, if the battery gets too hot, this may be a problem with the
portable electronics charging circuit and therefore should be checked by a qualified technician. Rechargeable
batteries undergo self-discharging when unused for long periods of time. This is normal, especially in the case of Ni --
MH and Li-ion chemistry. For best results, always keep a fully charged battery. It should be removed from the
equipment and kept in a cool, dry and clean. The amount Pack runtime of a battery occurs depends on the power
the requirements of the components of your electronic equipment.
Do not allow children to keep batteries charged you to take great photos.
If you often use your digital camera, you may think that after using your digital camera, recharge your NiMH
batteries, wait a few weeks or months, and then use your digital camera, that your batteries will be charged and was
ready to photograph them, right?
Oops ... Do that and you're stuck with a lack of operating the digital camera or one that only flashes a picture that shows a dead
battery.
Rechargeable batteries do not stay charged forever. They tend to lose some of their power every day. If you load
their batteries and often use their digital camera, you probably are not aware of this loss of power. However, after a
couple of weeks, the power loss can be substantial, and after a couple of months or more from the lack of use, which, once ready to go
batteries may have lost the power to make them unusable.
Do not fall into this trap. Always at your office /> <br /> Battery.org "> batteries before every trip, and be sure to use a charger battery with a sensor that prevents over-charging.
More Info: href = "http://www.camera-battery.org"> http://www.camera-battery.org
About the Author:
Article Source: ArticlesBase.com - Digital Camera Battery Tips
Battery Flash
Battery Flash
